Table of Contents
Advertisement
THE ARTICLES MENTIONED BELOW ARE APPLICABLE ONLY FOR
THE UNITED STATES AND CANADA.
1. NOISE EMISSION WARRANTY
SANYANG INDUSTRY CO.,LTD. warrants that this exhaust system, at the time of sale,
meets all applicable U.S. EPA Federal noise standards. This warranty extends to the first
person who buys this exhaust system for purposes other than resale, and to all subsequent
buyers. Warranty claims should be directed to:
3,chung-Hua Road, Hukou, Hsin-Chu Taiwan, R.O.C
Tel:+886 35981911
2. TAMPERING WARNING
Tampering with noise control system prohibited. Federal law prohibits the following acts or
causing thereof:
(1) The removal or rendering inoperative by any person other than for purposes of
maintenance, repair, or replacement, of any device or element of design incorporated
into any new vehicle for the purpose of noise control prior to its sale or delivery to the
ultimate purchaser or while it is in use, or
(2) The use of the vehicle after such device or element of design has been removed or
rendered inoperative by any person.
Among those acts presumed to constitute tampering are the acts listed below.
(1) Removal of, or puncturing the muffler, baffles, header pipes or any other component
which conducts exhaust gases.
(2) Removal or puncturing of any part of the intake system.
(3) Lack of proper maintenance.
Replacing any moving part of the vehicle, or parts of the exhaust or intake system, with parts
other than those specified by the manufacturer .
3. SAFETY INFORMATION
Always wear your helmet (dot approved) correctly fastened. Do not carry loose items and
always wear suitable protective clothes, and protective eyewear.
Good psychophysical conditions are very important for safe operation.
Do not operate under the influence of drugs and/or alcohol.
Do not operate in state of physical fatigue or drowsiness.
Slow down on slippery surfaces , unfamiliar terrain and when visibility is reduced.
Be alert when operating this vehicle.
Do not exceed weight capacity.
The safety, stability and handling of this motorcycle may be adversely affected by the
addition of accessories or luggage.
Do not install accessory or replacement parts not approved by sym.
Failure to follow these warnings could lead to an accident, serious injuries or death.
Use unleaded fuel octane rating (R+M)/2 method of between 87&92.
Read owners manual carefully before operating this scooter.
Obey posted speed limit and other traffic signs and signals.
Fax:+886 35981844
t
80
Advertisement
Table of Contents
Related Manuals for Sym Scooter
Summary of Contents for Sym Scooter
-
Page 1: Safety Information
THE UNITED STATES AND CANADA. 1. NOISE EMISSION WARRANTY SANYANG INDUSTRY CO.,LTD. warrants that this exhaust system, at the time of sale, meets all applicable U.S. EPA Federal noise standards. This warranty extends to the first person who buys this exhaust system for purposes other than resale, and to all subsequent buyers. - Page 2 If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Sanyang Industry Co., Ltd. If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.
- Page 3 1. Contents ........................1 2. Control Location ......................3 3. Before Riding ........................ 4 4. Safe Riding ........................4 5. Driving ........................... 5 6. Use Genuine Spare Parts ..................... 5 7. Use of Each Component ....................6 ........................... 6 Gauges ....................
- Page 4 Diagnosis when Engine does not Start 12. C.D.I. Electrical Ignition System .................. 29 13. Suggestions on Engine Fuel ..................29 14. Transmission Oil ......................29 15. Cautions for Riding Scooter ..................29 16. Periodical Maintenance Schedule ................30 17. Specification ........................ 31 1. Contents...
- Page 5 ENG. Stop / Light / Starter switch Turn signal light Storage Pass High & beam Turn signal / Seat open Horn switch Fuses. Seat lock. Head light / Frame Foggy light number Fuel tank cap Tail light/ Turn signal light Side stand Main stand Front brake lever...
-
Page 6: Safe Riding
• After running, the exhaust pipe is very hot, be careful not to get burned when conducting an inspection or maintenance. • After running, the exhaust pipe is very hot, select a suitable location to park your scooter to avoid others getting burned by the exhaust pipe. -
Page 7: Use Genuine Spare Parts
• The scooter is hard to control on a bumpy, unleveled, unpaved road, try to know the road conditions in advance, slow down and use your shoulder’s force to control the handle. - Page 8 (The following is SYM 4 stroke liquid cooling scooter’s basic operation, and they could vary from different individual models. Please consult the end of this manual.) GAUGES High Beam Foggy Storage box Indicator Indicator Indicator EFi Indicator Battery Charge Alarm...
- Page 9 This odometer shows the total kilometers this scooter has been driven. Total kilometer : This shows the total kilometers of this scooter. It shows six digits; 5 in kilometers and 1 in hundred meter. (The total kilometer will return to zero if it runs over 100,000 kilometers.) Trip kilometer : The rider can measure the trip kilometers.
- Page 10 • How to lock：Push the fuel tank cap and it locks automatically. CAUTION: • Never operate the ignition switch key when the scooter is running. To turn the ignition switch to “OFF” and “LOCK,” will shut off the electrical system and that may result in a dangerous accident.
- Page 11 Note: Position Light Function: This light can indicate the scooter position when the scooter is running in dim, rainy, or foggy weather. When the switch is turned to this position as the engine is being started, rear light, instrument panel light, and position light will come on.
- Page 12 • Electrical Starter Button This is a starting motor button (switch) for engine starting. With the main switch "ON", press this button while holding the front or rear brake lever will start the engine. CAUTION: • Release this button immediately after engine has been started, and never press the button again to avoid damaging the engine.
- Page 13 Fog lamp Switch (If installed) This is for fog lamp. • Turn Signal Switch Turn signal lights are used when turning left/right or changing lane. Turn ignition switch to “ON”, and slide the turn signal switch to left or right. Then, the turn signal lights will flash.
- Page 14 GOODS HOOK • Hangs up the goods Goods hook SADDLE LOCK • Unlock: Insert the ignition switch key and turn to left to unlock. • Lock: Press the saddle down and it will be locked automatically. After the saddle has been locked, check to make sure it has been locked properly by lightly lifting the saddle.
- Page 15 • When refill the fuel, the flow rate should not be too big, in case of preventing the spurting to cause danger.
- Page 16 • Slow down and brake early when riding in rainy days on slippery roads. Never apply the brakes suddenly to prevent skidding and falling. • Using only the front brake increases the risk of falling because the scooter is tend to pulled to one side. For Front Wheel And...
- Page 17 • It is harder to get the engine started after the scooter has been left idle for a long time or after refueling only after the fuel has been depleted. Then, it is necessary to press starting lever or starter button several times, and keep the throttle valve handle at the close position to start the engine.
- Page 18 4. Get off the scooter from left side after the engine has been stopped, and select a parking place where the scooter will not interfere with traffic and the ground is level, then put down scooter’s main parking stand.
- Page 19 INSPECTION: 1. Use the main parking stand to support the scooter on a level ground, remove the dipstick after engine stopped for 3~5 minutes. Wipe oil off the dipstick and then insert it into the guide tube again (Do not rotate it.)
- Page 20 • This scooter’s engine is designed for using the unleaded fuel of Octane 90 or above. • Firmly secure the main stand on the ground, shut off the engine and keep flames away from the scooter when refueling.
- Page 21 CAUTION: • Please drive your scooter on a dry road surface slowly and operate front and rear brakes in order to find out if there is any malfunction so as to ensure the scooter is at its optimum condition and safe to ride.
- Page 22 ﹙Checking front brake lining﹚ ﹙Checking oil quantity in brake oil reservoir﹚ • • Park the scooter on a level ground, and check Check the brake from behind the brake caliper. The brake pad must be replaced with if fluid level is under the “LOWER” mark.
- Page 23 15 days, remove the battery from scooter and store it in a well-ventilated and dimly lighted area. Store battery out of reach of children. If the battery is to be kept on the scooter, disconnect the battery’s negative cable.
- Page 24 • Check steering handle if it is being pulled too tight by the brake cables. • Take your scooter to SYM Authorized Dealer or Franchised Dealer for a check or adjustment if any abnormal conditions are found. 10. Inspection and maintenance before riding...
- Page 25 Using parts not having the specified specifications for replacement may cause the fuse to blow and over-discharge the battery. • Avoid spraying water directly on or around fuse box when washing the scooter. • Take your scooter to your dealer for an inspection if a fuse is blown by unknown causes. Fuse box Burned fuse CHECKING THE TURN SIGNAL LIGHTS AND HORN •...
- Page 26 0.7~0.8mm WARNING: The engine is very hot after running. Pay attention not to get burned. ※Use only spark plugs suitable for the engine specifications of this scooter recommended by the manufacturer. (Refer to specifications.) 10. Inspection and maintenance before riding...
- Page 27 COOLING SYSTEM INSPECTION (Checking coolant lever) 1. Support vehicle with main stand on a level ground. 2. Check reserved tank from viewing window to see if coolant level is between the upper limit and lower limit mark. 3. Add coolant up to upper mark if coolant is close to the lower mark. (Check the cooling system for leakage) •...
- Page 28 (below 0℃) A reference table for anti-freeze concentration percentages under different temperatures 1. Radiator anti-freeze specification for this scooter is H68. (SYM Bramax radiator agent) 2. Proper anti-freeze percentages for different frozen temperatures are as follows:...
- Page 29 • Dust deposit is one of the major causes of reducing output horsepower and increasing fuel consumption. • Change the air cleaner element more frequently to prolong the engine’s service life if the scooter is driven on dusty roads very often.
- Page 30 【Have your scooter checked by SYM authorized dealer or franchised dealer immediately if there are no problems with the above items and engine still can not be started.】...
-
Page 31: Suggestions On Engine Fuel
• Never rotate the throttle valve handle at will to increase the engine RPM before driving off. 2. Get on the scooter from the left side, and sit on the saddle properly, keep your feet firmly on the ground to prevent the scooter from falling. - Page 32 C ~ Cleaning (replaced if necessary) L ~ Lubrication Remark: 1.Clean or replace the air cleaner element more often when the scooter is operated on dusty roads or in the Heavily- polluted environment. 2. Maintenance should be performed more often if the scooter is frequently operated in high speed and after the scooter has accumulated a higher mileage.
- Page 33 Model GTS 300i EVO GTS 250i EVO GTS 125 Item Specification LM30W-6 LM25W5-6 LM12W5-6 Length/ width / Height 2,165 mm(85 in) / 870 mm(34 in) / 1,395 mm(60 in) Net Weight 190 kg(419 lb) 167 kg(368 lb) maximum load 340 Kg(750 lb) 317 Kg(699 lb) Type 4- stroke 4V electroplated ceramic cylinders engine...