To Use Machine When Power Save Led Lights - Oce CS655 Pro User Manual

Preparation for use
2.4

To use machine when power save LED lights

If you find the Power Save LED lit on the control panel, the machine cannot be operated due to the Power
Save or Weekly Timer function.
To activate the machine
% Press any key on the control panel.
– If the machine makes no response, press [Power Save].
If Power Save has been activated, the machine will become
available for operations.
If Weekly Timer has been activated, the Machine Status
Screen will appear with the message "Timer interrupt mode/
Enter password" displayed in the message area, and the
machine operation will be available temporarily by the Timer
Interrupt function. See page 2-16 for details.
!
Detail
The Power Save function has two modes: Auto Low Power and Auto Shut-Off. See the following
description for details.
This function can also be activated manually. For details, see page 2-15.
Automatically conserving energy (Auto low power)
This function conserves energy by lowering the power consumption to the following extent in standby mode.
173.7 W
Auto Low Power activates automatically after a specified period of copier inactivity with the Power Save LED
lit, touch panel gone off, and all other LEDs except Start LED on the control panel turned off. The Start LED
will turn red, while the Power LED keeps green. This function is set to OFF (not used) as factory default.
Note
If the Auto Shut-Off function activates at the same time, the power will be turned off.
The touch panel will not go off during a duplex copying job or when the Jam Position Screen is
displayed.
!
Detail
The Auto Low Power function can be set to OFF/ 5 minutes/ 10 minutes/ 15 minutes/ 30 minutes/
60 minutes/ 90 minutes/ 120 minutes/ 240 minutes. See the User's guide – POD Administrator's
reference.
CS655 Pro
2
2-13