Changing Magnification Ratio - Oce CS655 Pro User Manual

9
9.4.2

Changing magnification ratio

The following four modes are provided.
- Zoom (proportional): 0.250 to 4.000 in 0.001 (0.1%) increments
- Zoom (individual): Vertical and horizontal zoom ratios can be specified individually within the range from
0.250 to 4.000 in 0.001 (0.1%) increments.
- Enlarge/Reduce: Select one from the eight ratios (0.500, 0.707, 0.816, 0.866, 1.154, 1.224, 1.414,
2.000) provided on the screen.
- Set Zoom: Select one from the three ratios previously programmed.
!
Detail
The Enlarge/Reduce and Set Zoom ratio setting is described in the User's guide – POD Administrator's
reference.
1
Touch [Zoom] on the Copy Screen.
2
Specify the desired magnification.
– Zoom (proportional):
Touch to highlight the proportional zoom key at the upper left corner in the Zoom area.
Then, use the screen keypad to enter the desired magnification ratio. The entered ratio will be
displayed on the screen.
– If wrong number is entered, continue by entering the correct number.
Touching arrow keys [+] and [,] will change the ratio in 0.001 (0.1%) steps.
– Zoom (individual):
Touch to highlight the vertical zoom key (the second one in the left side line) in the Zoom area, then
use the screen keypad to enter the desired lengthwise magnification ratio.
Similarly, touch the horizontal zoom key (the third one in the left side line) to enter the desired
widthwise magnification ratio. The entered ratio will be displayed on the screen.
If wrong number is entered, continue by entering the correct number.
Touching arrow keys [+] and [,] will change the ratio in 0.001 (0.1%) steps
9-20
Basic job settings
CS655 Pro