1-1] Slot-Port Property - Ip-Extension Port (Kx-Tde Series Only) - Panasonic KX-NCP500 Programming Manual

3.43 [1-1] Slot—Port Property - IP-Extension Port
(KX-TDE series only)
Various settings can be programmed for each IP extension port.
To change the status of extension ports, click Command.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming both the PBX and IP-PT before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-PT later.
Preparation
Follow the steps below to prepare before registering an IP-PT.
1.
Open 3.41 [1-1] Slot—Card Property - IP Extension (KX-TDE series only), and confirm that the IP
address and subnet mask settings of the IP-EXT16 card are correct.
2.
Open 3.42 [1-1] Slot—Card Property - IP Extension—Common Settings (KX-TDE series only), and
set the gateway address.
Registration
Follow the steps below to register the IP-PT.
1.
Connect the IP-PT to be registered to the network and, if necessary, the power supply.
2.
Click Registration.
A dialog box will appear. Non-registered (available) extension numbers and names are displayed on the
left.
3.
Highlight numbers and names and click the right arrow to select them for registration. Click Next.
4.
If the registration is still in progress, the dialog box will show "Registration Executing".
If the registration is successful, the dialog box will show "Registration Completed". Click Close.
Once the IP-PT is successfully registered, the status of the IP-PT will update to show "Registered".
De-registration
Follow the steps below to de-register the IP-PT.
1.
Click De-registration.
A dialog box will appear. Registered extension numbers and names are displayed on the left.
2.
Highlight numbers and names and click the right arrow to select them for de-registration. Click Next.
A dialog box will appear.
3.
Click Confirm.
If the de-registration is successful, the dialog box will show "De-registration succeed!".
4.
Click Close.
Once the IP-PT is successfully de-registered, the status of the IP-PT will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register the IP-PT when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the IP-PT.
1.
Click Forced De-registration.
A dialog box will appear. Registered extension numbers and names are displayed on the left.
Document Version 2011-10
3.43 [1-1] Slot—Port Property - IP-Extension Port (KX-TDE series only)
PC Programming Manual 331