Panasonic KX-NCP500 Programming Manual page 198

3.20 [1-1] Slot—Card Property - Virtual IPCS
Signaling (MGCP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-CS side. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Default
2427
Value Range
1024–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Manual References
None
Voice (RTP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive RTP (Realtime Transfer Protocol)
data. This must be changed if another network application is using the same port.
For voice communications, the V-IPCS card uses 128 contiguous UDP ports, starting from the port number
specified here.
To change the value displayed here, click Common Settings and set the desired value.
Default
12000
Value Range
1024–65024
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Manual References
None
198 PC Programming Manual Document Version 2011-10