4.2
Battery Pack
Removing the Battery Pack
To remove the T4500/T4600 Family computer's battery pack, follow the steps below and refer to
Figure 4-1.
1. Turn off the power to the computer; disconnect the AC adapter, power cord and all external
cables connected to it.
2. Close the display if it is open.
3. Slide open the cover to the battery latch and press the battery latch until it clicks. The
battery will pop out slightly.
4. Firmly grasp the battery pack and pull it out.
Installing the Battery Pack
NOTE: The battery pack is designed to fit into the computer in only one way.
To install the T4500/T4600 Family computer battery pack, follow the steps below and refer to
Figure 4-1:
1. Gently slide the battery pack into the battery slot making sure the groove on the side of the
battery faces left and the smooth side faces right.
2. Push the battery pack in until it locks into place.
4-4
Figure 4-1 Removing the Battery Pack
Groove