ADT Safewatch Pro 3000EN Installation And Setup Manual page 70

3000EN Series: Installation Instructions
✱
Z N 0 1
✱
Z N 0 1 B A C K
✱
Z N 0 1 B A C K
✱
Z N 0 1 B A C K
D O O R
✱
Z N 0 1 B A C K
D O O R
✱
Z N 0 1 B A C K
D O O R
9-2
Flashing Cursor
[∗] to continue
First 3-Digit Index No.
see index for entries
[∗] to continue
Accept First Word
6 = save word and go to
next word in this
descriptor
8 = save word and end
descriptor- go to next
zone
Second 3-Digit Index No.
see index for entries
[∗] to continue
Accept Second Word
6 = save word and go to last
word in this descriptor
8 = save word and end
descriptor- go to next zone
Summary Screen
[∗] to continue
To delete or change the default descriptor for zone 1, press [∗]
plus the same zone number (01). This will clear that
descriptor and allow changes to be made at the flashing
cursor.
NOTE: If you do not wish to change the existing descriptor for
zone 1, enter [∗] plus the next zone number for which you wish
to enter (or check) a descriptor. A summary display for that
zone will appear. You must then press [∗] plus the same zone
number again to gain access to the entry mode (flashing
cursor) for that zone.
Press [#] plus the 3-digit number for the first word from the
Alpha Vocabulary List. Example: The descriptor that we wish
to enter for zone 1 is BACK DOOR. From the list, BACK =
013. Therefore, you would enter #013.
Note: If you accidentally enter the wrong word, simply press
[#] plus the correct 3-digit number for the word you want.
Press [6] to accept the selected word and continue to the next
word.
NOTE: If this is the only word you are using for the
descriptor, press [8] instead of [6] to save that word in
memory.
Enter the 3-digit number for the next word. In our example,
the word is DOOR, whose number is "057."
Enter # 0 5 7.
Press [6] to accept the selected word.
NOTE: If these are the only words you are using for the
descriptor, press [8] instead of [6] to save them in memory.
The two words in our example have now been entered. Note,
however, that up to three words may be entered (provided the
number of characters will fit on the screen).
Press [8] to save all words in memory.
The flashing cursor will disappear, indicating that the word(s)
are stored in memory for that zone, as shown in the summary
display at the left.
To enter a descriptor for the next zone, press [ ✱] plus the
desired zone number (e.g., ✱ 02). The summary display will
appear. Now repeat the previous steps to enter the descriptor
for the next zone.
To exit the Alpha descriptor mode, press ✱ + 0 + 0 at the
summary display.