Toshiba 400CS User Manual page 54

5. Select the desired subtest number from the subtest menu and press Enter.
The following message will appear:
TEST LOOP
Selecting YES increases the pass counter by one each time the test cycle ends,
then restarts the test cycle.
Selecting NO returns the subtest menu to the main menu after the test is complete.
6. The following message will appear:
ERROR STOP : YES
Use the left or right arrow keys to move the cursor to the desired option and press
Enter.
Selecting YES stops the test program when an error is found and displays the
operation guide on the right side of the display screen as shown below:
ERROR STATUS NAME
These three selections function as follows:
1: Terminates the test program and exits to the subtest menu.
2: Continues the test.
3: Restarts the test from the error.
Selecting NO keeps the test running even if an error is found.
7. Use the arrow keys to move the cursor to the desired option and press Enter.
Table 3-1 in section 3.3 describes the function of each test on the subtest menu.
Table 3-3 in section 3.17 describes the error codes and error status for each error.
400 Series
: YES
[[ HALT OPERATION ]]
1: Test end
2: Continue
3: Retry
3-5