Toshiba 400CS User Manual page 163

7. Remove four M2x4 screws securing the SEG board. Remove the black protec-
tive tape and rotate the board out so that it lies flat. Be sure no dust or debris
contaminates the unit.
8. Slip your finger under the P chassis and release the latch securing it to the B/L
holder. Gently hold down the LCD module and lift one side of the B/L holder.
As you lift the B/L holder the P chassis securing the holder will rotate out. Be sure
to note the placement of the metal guides.
9. When the B/L holder is free, lift it out. Be careful not to lift the B/L holder too
high or apply pressure to the P chassis.
10. Disconnect the FL.
4-46
Figure 4-40 Removing SEG board screws
Figure 4-41 Disconnecting the B/L holder
400 Series