5.
Lift out the FL with its cables.
Installing the 400CDT FL
To install the 400CDT FL, follow the steps below and refer to figures 4-43 and 4-44.
1.
Route the FL cable into its groove and seat the FL.
2.
Replace the metal cover and secure it with one M2x2 and two M2x3 screws.
3.
Install the LCD module, FL inverter board, display mask, optional memory mod-
ule, optional PCMCIA card, and battery pack as described in sections 4.19, 4.18,
4.16, 4.4, 4.3, and 4.2.
400 Series
Figure 4-44 Removing the 400CDT FL
4-49