Toshiba 400CS User Manual page 48

2.9 CD-ROM Drive Troubleshooting
This section describes how to determine if the 400 series internal CD-ROM drive is function-
ing properly. Perform the steps below starting with Procedure 1 and continuing with the
other procedures as required.
Procedure 1:
Procedure 2:
Procedure 3:
Procedure 1 CD Cleaning Check
Clean the laser pickup lens with a lens cleaner. Apply the cleaner to a cloth and wipe the lens.
If the CD-ROM drive still does not function properly after cleaning, go to Procedure 2.
Procedure 2 Diagnostic Test Program Execution Check
The CD-ROM drive Diagnostic Test program is stored on the 400 series Diagnostics Disk.
After Toshiba MS-DOS loads, run the diagnostic program stored on the test program dis-
kette. Insert a test CD (Toshiba-EMI Test Disc TDY-03) into the CD-ROM drive and run
the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the diagnos-
tics test procedures.
If any other errors occur while executing the CD-ROM drive diagnostics test, go to Proce-
dure 3.
2-28
CD Cleaning Check
Diagnostic Test Program Execution Check
Connector Check and Replacement Check
400 Series