Toshiba 400CS User Manual page 105

If the changed item requires the system to reboot, the following message is dis-
played:
Are you sure? (Y/N)
The changes you made will cause the system to reboot.
2. To make other changes, press N. Repeat the steps above.
3. To accept the changes, press Y.
NOTE: You can press Esc to quit at any time without saving changes.
SETUP asks you to confirm that you don't want to save your changes.
The Factory Preset Configuration
When you access SETUP, the current configuration is displayed.
1. To show the factory preset configuration, press Home.
2. To accept the default settings, press End and then press Y.
NOTE: When you execute the default setting, the following settings are not
changed:
HDD Mode
Password
Sound System: I/O Address, Interrupt Level, DMA
Write Policy
SETUP Options
The SETUP screen is divided into functionally related groups. This section describes each
group and its options.
1. Memory
This option lists the computer's memory allocations. You cannot change these
values.
(a) Total
This field displays the total amount of memory installed and is automatically
calculated by the computer.
(b) Base
This field displays the amount of base (conventional) memory, 640 KB, and
is automatically calculated by the computer.
3-56
400 Series