Display Mask - Toshiba 400CS User Manual

4.16 Display Mask

Removing the Display Mask
To remove the display mask, follow the steps below and refer to figure 4-35.
1. Turn the computer's power off. Disconnect the AC power cord and all external
cables connected to the computer.
2. Remove the battery pack, optional PCMCIA card, and optional memory module as
described in sections 4.2 through 4.4.
NOTE: It is not necessary to remove the display assembly.
3. Remove two rubber seals from the display hinges to expose two screws securing
the display mask.
4. Remove two M2.5x6 screws covered by the rubber seals.
5. Carefully insert your fingers between the mask and the LCD panel and pry open
the latches. Start with the six latches across the top of the display mask..
6. Continue unlatching the mask along the sides (four latches on each side), at the
bottom (three latches), and also at the display supports (one latch at the small
display support and three latches at the larger display support are not indicated in
figure 4-35).
4-38
Figure 4-35 Removing the display mask
400 Series