Toshiba 400CS User Manual page 146

8. Remove the tape and disconnect the AccuPoint button contact cable from PJ10
on the sound card.
Figure 4-28 Removing the AccuPoint button contact
9. Remove the AccuPoint button contacts.
Installing the Sound Card and AccuPoint Button Contacts
To install the sound card, follow the steps below and refer to figures 4-27 and 4-28.
1. Seat the AccuPoint button contacts.
2. Connect the AccuPoint button contact cable to PJ10 on the sound card (figure
4-28).
3. Connect the power cable to PJ18 on the system board.
4. Connect the sound card cable to PJ7.
5. Seat the sound card and secure it with three M2.5x6 screws. Be sure to replace
the PR spring.
6. Lay the sound card cover in place and secure it with one M2.5x6 screw and one
M2.5x4 screw.
7. Connect the speaker cable to PJ6 on the sound card.
8. Install the top cover and display assembly, sub-battery and VGA board, keyboard,
HDD, diskette drive or CD ROM drive, optional memory module, optional
PCMCIA card, and battery pack as described in sections 4.10 back through 4.2.
400 Series
4-29