Table of Contents
Advertisement
3.11 Hard Disk Test
To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TEST menu, press Enter ,
and follow the directions displayed on the screen. The Hard Disk test contains 10 subtests
that test the T6600C's hard disk drive functions.
CAUTION: The contents of the hard disk will be erased when Subtest 02, 03, 04, 05,
06, 08, 09, or 10 is executed. Before running the test, transfer the contents of the hard
disk to a floppy disk(s). This can be done with the Toshiba MS-DOS BACKUP com-
mand.
After the Hard Disk test is completed, execute the Toshiba MS-DOS FDISK command,
which will set the partition. Then execute the Toshiba MS-DOS FORMAT command.
Refer to the Toshiba MS-DOS manual for details.
1.
When you select the hard disk test from the DIAGNOSTIC TEST menu, the
following message appears:
Test drive number select (1:HDD#1,2:HDD#2,0:HDD1&2) ?
Select the hard disk drive number to be tested and press Enter . The following
2.
message appears:
HDC F/W error retry
3.
This message is used to select the retry operation when the hard disk controller
detects an error. Select 1 or 2 and press Enter . The following message appears:
Data compare error dump
4.
This message is used to select the error dump operation when a data compare
error is detected. Select 1 or 2 and press Enter . The following message appears:
Detail status display
5.
This message is used to select whether or not the HDD status is displayed on the
screen. The HDD status is described in Section 3.16. Select 1 or 2 and press
Enter .
T6600C, T6600C/CD, T6600C/CDV
(1:yes,2:no) ?
(1:no,2:yes) ?
(1:no,2:yes) ?
3-27
Advertisement
Table of Contents
Troubleshooting
