Hard Disk Drive Troubleshooting - Toshiba T6600C User Manual

2.6

Hard Disk Drive Troubleshooting

To determine if the hard disk drive is functioning properly, perform the procedures below
starting with Procedure 1. Continue with the other procedures as instructed.
Procedure 1:
Procedure 2:
Procedure 3:
Procedure 4:
CAUTION: The contents of the hard disk will be erased when the HDD troubleshoot-
ing procedures are executed. Transfer the contents of the hard disk to a floppy disk(s)
using the Toshiba MS-DOS BACKUP command. Refer to the Toshiba MS-DOS Manual
for more information about how to perform the BACKUP command.
Procedure 1 Partition Check
Insert the Toshiba MS-DOS system disk and turn on the computer, then perform the follow-
ing checks:
Type C: and press Enter . If you cannot change to Drive C, go to Check 2. If
Check 1
you can change to Drive C, go to Procedure 2.
Check 2 Type FDISK and press Enter . Choose "Display Partition Information" from the
FDISK menu. If Drive C is listed, go to Check 3. If Drive C is not listed, return
to the FDISK menu and choose the option to create a DOS partition on Drive C,
then recheck the system. If the problem still exists, go to Procedure 2.
Check 3 If Drive C is listed as active in the FDISK menu, go to Check 4. If Drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for Drive C, then recheck the system. If the problem still exists, go to
Procedure 2.
Check 4 Remove the system disk from the FDD and cold boot the computer. If the prob-
lem still exists, go to Procedure 2. Otherwise, the HDD is operating normally.
T6600C, T6600C/CD, T6600C/CDV
Partition Check
Message Check
Format Check
Diagnostic Test Program Execution Check
2-21