Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
vlan < vid > qos dscp < codepoint >
N o t e s
A codepoint must have an 802.1p priority before you can configure it for use
in prioritizing packets by VLAN-ID. If a codepoint you want to use shows No
Override in the Priority column of the DSCP policy table (display with show qos
dscp map, then use qos-dscp map < codepoint > priority < 0 - 7 > to configure a
priority before proceeding. For more on this topic, refer to the chapter titled
"Quality of Service (QoS): Managing Bandwidth More Effectively" in the
Advanced Traffic Management Guide for your switch.
Enabling or Disabling medTlvEnable on 5300xl or 4200vl Switches.
In the default LLDP-MED configuration, the TLVs controlled by medTlvEnable
are enabled.
15-51