ProCurve 6400cl Management And Configuration Manual page 218

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Figure 10-6. Examples of Two Methods for Changing a Port Configuration
10-10
Note that in the above syntax you can substitute an "int" for "interface"; that
is: int < port-list >.
For example, to configure ports C1 through C3 and port C6 for 100Mbps full-
duplex, you would enter these commands:
ProCurve(config)# int c1-c3,c6 speed-duplex 100-full
Similarly, to configure a single port with the above command settings, you
could either enter the same command with only the one port identified, or go
to the context level for that port and then enter the command. For example,
to enter the context level for port C6 and then configure that port for 100FDx:
ProCurve(config)# int e c6
ProCurve(eth-C6)# speed-duplex 100-full
If port C8 was disabled, and you wanted to enable it and configure it for
100FDx with flow-control active, you could do so with either of the following
command sets. (Note that to enable flow control on individual ports, you must
first enable it globally, as shown in these examples.)
Refer to "Enabling or Disabling Flow Control" on page 10-11 for more on flow
control.
These commands enable and configure
port C8 from the config level:
This command enables flow control
globally on the switch (which is
required before you can enable flow
control on specific ports).
These commands select the port C8
context level and then apply the
subsequent configuration commands
to port C8: