Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Example of
Community
Name Data (See
page 15-11.)
Example of Trap
Receiver Data
Figure 15-9. Example of Show SNMP-Server Listing
N o t e
15-20
Configuring Trap Receivers. This command specifies trap receivers by
community membership, management station IP address, and the type of
Event Log messages to send to the trap receiver.
If you specify a community name that does not exist—that is, has not yet been
configured on the switch—the switch still accepts the trap receiver
assignment. However, no traps will be sent to that trap receiver until the
community to which it belongs has been configured on the switch.
Authentication
Trap Setting