Configuring Uplink Network Ports; Configuring The Uplink Vlan - ProCurve 6400cl Management And Configuration Manual

Access Controller xl Module for the Series 5300xl Switches
Configuring the Access Controller xl Module

Configuring Uplink Network Ports

Uplink network ports are any switch ports that are members of the uplink
VLAN, that is, the VLAN where the ACM's internal uplink port is an untagged
member. By default, the uplink port (<slot-id>UP) is an untagged member of
the DEFAULT-VLAN on the 5300xl switch. In this default configuration, all
members of the DEFAULT-VLAN are uplink network ports.

Configuring the Uplink VLAN

To change the uplink VLAN, make the internal uplink port an untagged member
of a new VLAN. Be sure that the new VLAN allows communication with the
740wl/760wl, or communications is lost.
ProCurve (Config)# vlan 25 untagged <slot-id>up
where slot-id is the 5300xl switch slot where the ACM module is installed.
This command configures a new uplink VLAN, VID 25, for the ACM module
installed in slot n.
12-19