Configuring Jumbo Packet Operation - ProCurve 6400cl Management And Configuration Manual

Configuring Jumbo Packet Operation

Command
show vlans
show vlans ports < port-list > 14-31
show vlans < vid >
jumbo
Overview
1. Determine the VLAN membership of the ports or trunks through which
you want the switch to accept inbound jumbo traffic. For operation with
GVRP enabled, refer to the GVRP topic under "Operating Rules", above.
2. Ensure that the ports through which you want the switch to receive jumbo
packets are operating at least at gigabit speed. (Check the Mode field in
the output for the show interfaces brief < port-list > command.)
3. Use the jumbo command to enable jumbo packets on one or more VLANs
statically configured in the switch. (All ports belonging to a jumbo-
enabled VLAN can receive jumbo packets.
4. Execute write memory to save your configuration changes to the startup­
config file.
Jumbo Packets on the Series 3400cl and Series 6400cl Switches
Page
14-30
14-32
14-32
Port Traffic Controls
14-29