Removing The Oil Filter; Installing The Oil Filter - KTM 690 Enduro EU 2009 Repair Manual

38/LUBRICATION SYSTEM

Removing the oil filter

23.6
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.

Installing the oil filter

23.7
–
Thoroughly clean the oil drain plug with a magnet.
–
Mount the oil drain plug with the magnet and seal ring and tighten it.
Guideline
Oil drain plug with magnet
100201-01
–
Place a suitable container under the engine.
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
100202-10
–
Remove screws
–
Pull oil filter
Circlip pliers reverse (51012011000) (
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
100203-10
–
Insert oil filters
–
Oil the O-rings of the oil filter cover. Fit the oil filter covers
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
100204-10
. Remove the oil filter cover

out of the oil filter housing.

. Remove oil filter with the O-ring.
 
out of the oil filter housing.

and .
 
M12x1.5 20 Nm
(14.8 lbf ft)
with the O-ring.

p. 246)
p. 246)
and .
 
M5 6 Nm (4.4 lbf ft)
173