Adjusting The Basic Setting Of The Motor Drive - KTM 690 Enduro EU 2009 Repair Manual

41/THROTTLE VALVE BODY

Adjusting the basic setting of the motor drive

25.2
–
Adjust the basic setting of the motor drive. (
–
Use "Continue" to start the "Checking the position of the throttle grip sensor" menu.
The motor drive keeps the throttle valve in the emergency running position.
–
Check the voltage value.
Info
The "Continue" button only appears if the measured value equals the set-
point value.
Throttle grip sensor
400537-51
Voltage "APAD"
» If the displayed value is not equal to the setpoint value:
–
Close the menu with "Exit".
–
Adjust the basic setting of the motor drive. (
–
Close the menu with "Continue".
Condition
The diagnostics tool is connected.
–
Remove the air filter box. (
–
Disconnect the connector of the motor drive DR
–
Switch on the ignition by turning the ignition key to position ON
–
Select model.
–
Select "ECU Diagnostics".
–
Highlight "EPT throttle motor drive control LC4" control unit.
–
Press "Continue".
–
Select "Adjustment".
–
"Please enter the password:"
601136-10
–
Press "Continue".
–
Select "Adjusting the basic setting of the motor drive".
–
Press "Continue".
–
Read the information page in the KTM diagnostics tool and use "Continue" to open
the "Adjusting the position of the throttle position sensor in circuit A" menu.
400786-60
p. 179)
0.70... 0.74 V
p. 179)
p. 63)
.

179
.