Fat Channel: Output Assignments; Copying, Loading, And Storing Fat Channel Settings - PRESONUS StudioLive24.4.2 Owner's Manual

4 Controls
4.1 The Fat Channel

4.1.5 Fat Channel: Output Assignments

4.1.6 Copying, Loading, and Storing Fat Channel Settings

36 36
Because the settings are copied nondestructively, it is possible to A/B
dynamics settings with the touch of two buttons. Whichever channel
is selected when the Link button is engaged will be the Link Master.
When either channel in the stereo link is selected, both channels'
Select buttons will illuminate, but the Link Master's ID number will be
displayed in the Selected Channel LED read-out in the Fat Channel.
Subgroups can only be assigned to the main outs, and the ten aux
sends cannot be assigned to a subgroup or to the main outputs.
Any channel on the input bus can be assigned to any or all of the
subgroup outputs, as well as to the main outputs. This includes the 24
main inputs and the 2 auxiliary inputs. The internal effects returns can also
be assigned to any or all of the subgroups and to the main outputs.
The Fat Channel also gives you the option of sending just the unprocessed audio to
your computer or including the Fat Channel settings in the recorded signal. When
the Dig Out button is enabled, the signal being sent to the FireWire bus is post-EQ
and post-dynamics processing; the button will illuminate to indicate this signal
flow. When the button is disabled, the signal being sent to the FireWire bus is
pre-Fat Channel. The Dig Out button is only available when one of the 24 channel
inputs is selected. The subgroups, main output, aux bus, aux inputs, and internal
effects returns automatically send their signals post-Fat Channel dynamics and EQ.
All FireWire sends are pre-fader except for the subgroups and the main outputs. For
more information on using your StudioLive as an audio interface, please consult
Section 6.
Every setting in the Fat Channel can be copied from one to channel to
another and can be saved and stored as a user preset to be recalled later.
Press the Copy button to copy the settings on the selected channel or bus. Every
Select button on the StudioLive except the button for the currently selected
channel will begin to flash. The Select button for the selected channel will not
illuminate. You can copy a Fat Channel setting from any channel or bus to any
combination of channels and buses.
The Load button will also start to flash.
To paste the current channel's Fat Channel setting to another channel or bus,
simply press that channel's Select button. It will stop flashing and illuminate. After
you have selected every channel to which you want the settings pasted, press the
Load button. The StudioLive will return to its normal state, indicating that the Fat
Channel settings have been successfully pasted.
PreSonus StudioLive
Output assignments are set within the Fat
Channel. It should be noted that the StudioLive
will prevent you from creating a feedback loop.
™ 24.4.2