Metering; Studiolive Metering Controls - PRESONUS StudioLive24.4.2 Owner's Manual

Owner's Manual
4.2

Metering

Finally, the meters can be used to recall the fader settings for a saved Scene.

4.2.1 StudioLive Metering Controls

Input Metering Button
Output Metering Button
The Load button can also be used to recall saved settings and
presets. For complete recall instructions, see Section 5.2.
You can save your Fat Channel settings for future use. To store the currently
selected channel's Fat Channel settings, press the Save button. For complete
channel-preset storage instructions, see Section 5.2.
Th
The StudioLive offers flexible metering at the touch of a button. The 24 meters in
the Fat Channel section can monitor:
All 24 inputs, post-gain and pre-dynamics, pre-EQ, and pre-fader
All 24 inputs, post-dynamics, post-EQ, and post-fader
The gain reduction for all 24 inputs
The output volume of each of the 10 aux sends
The output volume of both of the internal effects buses
The Meters section of the StudioLive is located below the System
section. Each of these buttons are toggle switches; you turn them on
and off by pressing them. The meter state can also be changed by
pressing another button in the Meter section, or any Select button on
the StudioLive, or a Mix or Mix/Pan button in the Aux section.
It is important to mention that the meters simply overlay the selected Fat Channel
state. For instance, if you have Channel 16 selected and then press the Output
button in the Meter section, the knobs and buttons in the Fat Channel section
will still be active, and any changes made will be applied, but the changes will
not be displayed in the Meter section. The advantage of this is that you can make
adjustments in the Fat Channel, press a Meter button, and monitor your entire mix,
then press the same button to return to setting up your Fat Channel selection.
Turns PFL Input Metering On and Off.
Switches the meters to display the pre-dynamics, pre-fader level of the input bus.
Meters are one to one (Meter 1 shows the level of Channel 1, etc.).
Turns Post-Fader Output Metering On and Off.
Switches the meters to display the post-dynamics, post-fader level of the Input bus.
Meters are one to one (Meter 1 shows the level of Channel 1, etc.).
Controls 4
Metering 4.2
37 37