Solo Mode - Kawai CP 1 Owner's Manual

To set the RIGHT3 Type, Solo Priority. and Solo Trigger Mode:
Step 1
Press and hold the KBD SETTINGS button.
The KBD SETTINGS screen will be displayed.
Step 2
Touch RIGHT3 TYPE, SOLO PRIORITY or TRIGGER MODE and use the dial to assign a setting.
Step 3
Press the KBD SETTINGS button to exit.

SOLO MODE

When using RIGHT3 part, you can select between two Solo Modes.
Layer
The sound assigned to the RIGHT3 part will be layered on top of the RIGHT1 and RIGHT2 Parts.
Split
Only the sound assigned to the RIGHT3 part will be heard when you play above a specified key (split point) on the keyboard.
The default split point is C6 but you can freely change the split point to any key on the keyboard. When the RIGHT3 Part
is activated in Split mode the split point will be displayed in the LCD screen using the same 88 note diagram that is used
to display the LEFT/SPLIT split point. The keys assigned to the Solo part above the specified split point will be shown with
a black bar above them. There is no arrow to indicate the Solo split point because the split point for the Solo Part cannot
be changed on the main screen.
To set the Solo Mode and Solo Split point:
Step 1
Press and hold the KBD SETTINGS button.
The Performance screen will be displayed.
Step 2
Touch SOLO MODE and use the dial to select the mode.
Step 3
If the Solo Mode is set to Split, then touch SOLO SPLIT POINT and use the dial or keyboard to set the
split point.
Step 4
Press the KBD SETTINGS button to exit.
Left and Center pedal override and KBD SETTINGS button assign settings are not memorized by the registrations.
Registrations do memorize the system settings for these functions. This is so the KBD SETTINGS Button settings can
operate as an override to the Registration settings for these functions.
The KBD SETTINGS button settings will remain as long as the power is turned. Once the power is turned Off the KBD
Settings button settings will return to the factory defaults. If you would like to have the CP remember your KBD SETTINGS
button settings you can save your settings by selecting "Save Current Settings" from the Power Up Settings screen (See
Power Up settings on page 115).
Page
37
3