Yamaha VK540EF Service Manual page 75

FRONT SUSPENSION
3. Tighten:
Suspension bracket nut:
43 Nm (4.3 mDkg, 31 ftDlb)
Set screw:
2 Nm (0.2 mDkg, 1.4 ftDlb)
LOCTITE
NOTE:
Install the suspension bracket so that the "L"
mark is on the left side and the "R" mark is on the
right side.
4. Tighten:
Absorber holder bolt:
10 Nm (1.0 mDkg, 7.2 ftDlb)
Shock absorber nut:
5 Nm (0.5 mDkg, 3.6 ftDlb)
Locknut (shock absorber):
16 Nm (1.6 mDkg, 11 ftDlb)
Front arm nut:
43 Nm (4.3 mDkg, 31 ftDlb)
NOTE:
Be sure to install the front arms so that the "UP-
PER" mark is located in the upper position and
the "LOWER" mark is in the lower position.
CAUTION:
Always use a new cotter pin.
3-11
CHAS