Yamaha VK540EF Service Manual page 127

CYLINDER HEAD AND CYLINDER
CAUTION:
D Always use new piston pin clips.
D Do not allow the clip gap to align with the
piston pin slot.
5. Check:
D Piston ring position
CAUTION:
D Make sure that the ring ends are properly
fitted around the ring locating pins in the
piston grooves.
D Be sure to check that the manufacturer's
marks or numbers stamped on the rings
face upward.
6. Install:
D Gasket (cylinder)
7. Install:
D Cylinder
NOTE:
Install the cylinder with one hand while com-
pressing the piston rings with the other hand.
8. Tighten:
D Nuts (cylinder)
NOTE:
Tighten nuts in crisscross pattern.
5-12
ENG
Nuts (cylinder):
25 Nm (2.5 mDkg, 18 ftDlb)