Yamaha VK540EF Service Manual page 107

BRAKE
D Screw in the adjusting screw 1 , and when it
contacts lightly with the end of the back up
plate, then back out the adjusting screw 1 1/2
to turn.
D Fit the end of the adjusting ratchet 1 into the
adjusting screw 2 , and align the cut in the
guide 3 with the projection of the stationary
cover 4 , then install the guide 3 , which is
fitted to the end cover 5 twisting the end cover
clockwise approximately 30 degrees and tight-
en the screws (end cover) 6 .
Screw (end cover) 6 :
2 Nm (0.2 mDkg, 1.4 ftDlb)
2. Install:
D Brake pads
NOTE:
When installing the brake pad at the caliper
body side, make sure that projection a on the
brake pad are meshed with slot b on the caliper
body.
3. Tighten:
Brake caliper body bolt 1 :
48 Nm (4.8 mDkg, 34.7 ftDlb)
4. Adjust:
D Brake lever free play
4-32
POWR
TR