Removing The Communication Pcb Unit; Preparation; Procedure - Canon L100 Service Manual

4
Disassembly/Assembly > Controller System > Removing the Communication PCB Unit > Procedure
CAUTION:
Be sure to keep the Transfer High Voltage Harness [1] from the Engine Controller PCB
when assembling.
[1]
CAUTION:
Be sure to keep the AC cable [1] from the Fuse Holder [2] when assembling.
4 Disassembly/Assembly > Controller System > Removing the Communication PCB Unit > Procedure

■ Preparation

1) Remove the Left Cover (Refer to page 4-27).
2) Remove the Right Cover (Refer to page 4-28).
[1]
3) Remove the Rear Cover (Refer to page 4-29).

■ Procedure

1) Disconnect the connector [1] and Flat Cable [2].
2) Free the harness [1] from the Harness Guide [A].
F-4-75
3) Remove the Communication PCB Unit [1].
• 2 Screws (black TP) [2]
• 4 Hooks [3]
F-4-76

Removing the Communication PCB Unit

[2]
x2
[A]
[1]
x2
[2]
[3]
4-44
F-4-77
[2]
[3]
[1]
[3]
F-4-78
4-44