Summary of Contents for Canon FAXPHONE L170 Set-up
Page 1
Set-Up Instructions Set-Up Instructions Thank you for purchasing the Canon FAXPHONE L170. To get your machine ready for use, please follow the instructions in this document before referring to any other documentation. Unpack the machine and its components. Check that you have the following:...
Remove the shipping materials from the machine. 1 Place the machine on a flat surface. 2 Remove all shipping tapes from the exterior of the machine. 3 Open the document feeder tray by flipping it down. 4 Gently open the operation panel by grasping it at the center and pulling it up.
Load paper. 1 Pull out the paper cassette. 2 Adjust the rear paper end guide to match the paper size. 3 Load the paper into the cassette. Make sure the paper stack sits below the hooks. 4 Adjust the blue side paper end guides to match the paper size. Make sure the height of the paper stack does not exceed the limit marks 5 Insert the cassette into the machine as far as it will go.
Page 4
Connect the handset and telephone line cord. Telephone line cord Connect the supplied telephone line to the Then connect the other end to the telephone line jack on your wall. External device (optional) Connect the cord of an extension telephone, answering machine or data modem to the NOTE...
Page 5
Install the S35 S-Cartridge. 1 Make sure the machine is plugged in. 2 Remove the cartridge from the bag. Keep the bag in a safe place for future use. 3 Gently rock the cartridge several times to evenly distribute the toner inside. INSTRUCTIONS 4 Hold the cartridge on a flat stable surface with one hand, and break the tab and pull out the seal completely with the other hand.
Page 6
Set the fax receive mode. 1 Open the One-Touch Speed Dial panel. ➊ 2 Press [Receive Mode] 3 Press [Receive Mode] repeatedly until the mode you want appears in the LCD.“FAX ONLY” is the default setting. Select from the following: FAX ONLY: Answers all calls as fax calls.
Page 7
Install the Printer Driver. (Windows 98/Me/2000/XP) IMPORTANT • DO NOT connect the USB cable before installing the software. NOTE • When installing the software in Windows XP or Windows 2000, log onto the system as a member of the Administrator group. •...