Panasonic KX-FLM652CX Service Manual page 88

KX-FLM652CX
6.6.5.2. RECORDING PAPER FEED
No. Symptom
1 MULTIPLE FEED (P.104)
2 THE RECORDING PAPER
IS WAVED OR WRINKLED
(P.104)
3 SKEW (P.105)
4 THE RECORDING PAPER
DOES NOT FEED (P.106)
5 THE RECORDING PAPER
JAM(P.107)"PAPER
JAMMED" ON THE LCD
6 BACK SIDE OF
RECORDING PAPER IS
DIRTY(P.109)
Cause
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Dirty the pressure roller or the heat roller
Failed the spring of pressure roller
Too thin recording paper
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Dirty or failed the paper feed roller
Dust on the recording paper path
Failed LSU
Over the max capacity of the recording paper Set up to MAX 150 sheets
Too thick or too thin recording paper
Dirty or failed the pickup roller
Dirty or failed the pickup rubber
Failed the gear
Failed the engine motor
Failed the paper feed sensor lever
Failed the paper feed sensor
Dirty or failed the pressure roller
Dirty or failed the heat roller
Dust on the recording paper path
Failed the paper feed roller
Failed the gear
Failed the engine motor
Failed the paper feed sensor lever
Failed the paper feed sensor
Failed the exit sensor lever
Failed the exit sensor
Too thick or too thin recording paper
Not set the toner bottle
THE Dirty the recording paper path
Dirty the pressure roller
Dirty the regist roller
Failed the high-voltage terminal
Failed the high voltage power supply board
Clean or replace the pickup roller
Clean or replace the separation rubber
Clean the pressure roller and the heat roller
Replace the spring of pressure roller
Use the recording paper from 60g/m
Clean or replace the pickup roller
Clean or replace the separation rubber
Clean or replace the regist roller
Clean the recording paper path
Replace LSU
Use the recording paper from 60g/m
Clean or replace the pickup roller
Clean or replace the separation rubber
Check the gear
Go to ENGINE MOTOR (P.143)
Check the regist sensor (paper top sensor) lever
-----
Clean or replace the pressure roller
Clean or replace the heat roller
Clean the recording paper path
Replace the regist roller
Check the gear
Go to ENGINE MOTOR (P.143)
Check the regist sensor (paper top sensor) lever
-----
Check the exit sensor lever
Go to PAPER EXIT SENSOR..... "PAPER JAMMED" (P.189)
Use the recording paper from 60g/m
Set toner bottle
Clean the recording paper path
Clean the pressure roller
Clean the regist roller
Check the high-voltage terminal
Go to HIGH VOLTAGE SECTION (P.148)
88
Countermeasure
2 2
to 90g/m
2 2
to 90g/m
2 2
to 90g/m