Panasonic KX-FLM652CX Service Manual page 226

KX-FLM652CX
Bit No.
44
45
46
47
48
Note 1 - Standard facsimile units conforming to T.2 must have the following capability: Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability: Index of cooperation (IOC)=264.
Note 3 - Standard facsimile units conforming to T.4 must have the following capability: Paper length=297 mm.
Signal
Training 1
TCF
(Training Check)
CFR
(Confirmation to Receive)
Training 2
Image Signal
RTC
(Return to Control)
EOP
(End of Procedure)
MCF
(Message Confirmation)
DCN
(Disconnect)
MPS
(Multi-Page Signal)
PRI-EOP
(Procedural Interrupt-EOP)
PIP
(Procedural Interrupt Positive)
b. Redundancy Compression Process Coding Mode
This unit uses one-dimensional MH format.
DIS/DTC
Inch based resolution preferred
Metric based resolution preferred
Minimum scan line time capability for higher resolutions
"0": T = T "1": T = 1/2T
15.4 7.7 15.4
Selective Polling capability
Extend field
Identification Signal Format
———————
———————
X0100001
———————
Refer to the next page.
———————
X1110100
X0110001
X1011111
X1110010
X1111100
X0110101
Resolution type selection
"0": neuritic based resolution
"1": inch based resolution
Don't care
Don't care
7.7
Set to "0".
Extend field
A fixed pattern is transmitted to the receiving side at a speed
(2400 to 14400 bps) designated by DCS, and the receiving side
optimizes the automatic equalizer, etc., according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed as the
training signal.
Notifies the sending side that TCF has been properly received. If
TCF is not properly received, FTT (Failure To Train) X0100010 is
relayed to the sender. The sender then reduces the transmission
speed by one stage and initiates training once again.
Used for reconfirming the receiving side like training 1.
Sends 12 bits (0...01 × 6 times) to the receiver at the same speed
as the image signal and notifies completion of transmission of the
first sheet.
End of one communication
End of 1 page reception
Phase E starts.
Completion of transmission of 1 page. If there are still more
documents to be sent, they are output instead of EOP. After MCF
reception, the sender transmits an image signal of the second
sheet.
If there is an operator call from the sender, it is output after RTC.
This is output when an operator call is received.
226
DCS
Function
———————