Basic Playback - JVC HM-HDS1EU Instructions Manual

Basic Playback

Turn on the TV and select the AV mode.
If the recorder is turned on with HDD deck selected,
there may be about 30 seconds' delay in starting to
show pictures on the screen.
A
Turn on the recorder.
Press 1.
The button corresponding to the previously selected deck
lights on the recorder.
B
Select the HDD deck.
Press HDD.
The HDD button lights on the recorder.
C
Start playback.
Press .
4
The HDD playback indicator lights on the recorder.
One of the following screens will appear:
– the programme which has been recorded on the HDD deck at
last time and has not been played back yet
– the programme which has been stopped during playback
– the HDD Navigation screen (
There are some programmes for demonstration on the HDD
deck when it is shipped from the factory.
D
Pause playback.
Press .
9
To resume normal playback, press
E
Stop playback.
Press 8.
The HDD playback indicator turns off.
NOTE:
While recording a programme, you can play back the previously
recorded part by "Live Memory Playback" (
Recording Speed on the HDD deck
This recorder has a 40 Gbyte hard disk drive. The pictures and
sounds recorded on the HDD deck and other information are
written down on the hard disk drive.
As recording format for the HDD deck, MPEG2 format, the same
for DVD, is used. As a guide for picture quality, the "bps" unit is
used to represent how much data can be recorded per second.
The larger this value, the better the picture quality is but the
more capacity is required for recording. Select SP for
programmes where quick movement occurs, such as sports
programmes, and SEP for talk shows, etc. where relativity less
movement.
The recording speeds of the recorder are set as follows:
Recording Recording amount
speed (approx.)
SP 6.4 Mbps
LP 4.5 Mbps
EP 3.2 Mbps
SEP 2.2 Mbps
23
EN
pg. 24)
.
4
pg. 26).
Maximum recording
time (approx.)
14 hours
20 hours
28 hours
40 hours