Igmp Static Group Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

IGMP Static Group Settings

This window is used to display and configure the IGMP static group settings. Use this window to create an IGMP static
group in the case that the attached host does not support the IGMP protocol. Once configured, the group member
entry is added to the IGMP cache.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IGMP > IGMP Static Group
Settings, as shown below:
The fields that can be configured are described below:
Parameter
Interface VLAN
Group
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.
IGMP Dynamic Group Table
This window is used to find, clear and display IGMP dynamic group information. The IGMP buffer includes a list that
contains the dynamic multicast groups that the hosts in the direct subnet join. Use this window to clear the dynamic
group information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > IGMP > IGMP Dynamic Group
Table, as shown below:
The fields that can be configured are described below:
Parameter
Interface VLAN
Figure 6-97 IGMP Static Group Settings Window
Description
Enter the VLAN interface ID here. The range is from 1 to 4094.
Enter the IP multicast group address here.
Figure 6-98 IGMP Dynamic Group Table Window
Description
Enter the VLAN interface ID here. The range is from 1 to 4094.
282