Table of Contents
Advertisement
PREPARATION FOR USE
1.
With a nylon 1/4-inch x 6/32 screw, secure the 1/2 inch spacer
(Figure 2-13) to the iSBC 86/14/30 board in the mounting hole for
the Multimodule board being installed (refer to Figure 2-14) for
hole location).
If installing a double-wide Multimodule board
onto the iSBC 86/14/30 board, mount 2 spacers as shown in Figure
2-13.
2.
Locate pin 1 on the iSBX bus connector (P1) and align it with pin
1 of the iSBX connector on the iSBC 86/14/30 board that the
Multimodule board is to mount on.
3.
Align the Multimodule board mounting hole with the spacer(s) on
the iSBC 86/14/30 board.
4.
Gently press the two boards together until the connector seats.
S.
Secure the Multimodule board to the top of the spacer with the
other 1/4-inch x 6/32 nylon screw.
(Refer to Figure 2-13).
I
MUL TIMODULETM BOARD
1/2"
THREADED NYLON SPACER
I
MICROCOMPUTER BOARD
1/4"
x
6/32 NYLON SCREW
Figure 2-13.
Spacer Installation Technique
2-79
Advertisement
Table of Contents
