Continuing With Recording Upon Recovery From Power Failure - JVC VR-716E Instructions Manual

Continuing with Recording Upon Recovery from Power Failure

VR-716 is equipped with a Recovery Recording feature that starts recording automatically upon recovery from a power failure. With
this feature, restoration procedure will not be required when a power failure occurs during recording.
1.4.
SEARCH MENU
REV
EXECUTE
SKIP
2. 3.
Note
• The "POWER OUTAGE LOG IS UPDATED"
message will be displayed on the monitor
only when the "WARNING" item in the
"ONSCREEN MODE" Menu (☞ page 23)
is set to "ON". Press the [CANCEL] button
to clear the message display.
Caution
• Hard Disk Checking is performed upon re-
covery from a power failure, which may take
a while before recording starts. It may take
a long time when the data is fragmented or
when there is a large amount of recorded
data.
• A list containing the date and time at which
power failure is restored can be viewed.
(☞ Page 60)
• When the Program Timer is set, recording
will resume in the same mode after restor-
ing from a power failure.
HDD
OPERATE
FWD
LOCK
OUT
VIDEO AUDIO
1.
Press the [MENU] button
• Follow procedures in 'Changing Menu Settings' on page 22 to display
the "OPERATION/EXT REC" Menu.
MENU
2.
Press [ ] to select the
"RECOVERY REC" item
• Move the cursor to select.
3.
Turn the jog dial to select an operating mode
• "PRIOR STATE":
When a power failure occurs during
recording, recording will start again
upon restoration. If power failure occurs
when the equipment is in the Sensor
Record mode (☞ page 66), however,
recording will not start automatically
upon restoration.
• "NORMAL REC":
Recording resumes upon recovery from a power failure, regardless of
the mode prior to the failure.
4.
Press [MENU] to end setting
• The display returns to the normal screen.
MENU
Notification of Power Outage
• The following message will be displayed on the monitor screen when
a power outage occurs, and the [other E-04] message will appear on
the front display.
01-03-2003 SA 12:34:56
100%
AL-0
POWER OUTAGE LOG IS UPDATED
OPERATION/EXT REC
[ OPERATION ]
1.RECOVERY REC OFF
2.REPEAT REC OFF
3.LANGUAGE SELECTION ENGLISH
4.WATER MARK OFF
5.OPERATION LOCK ALL
[EXT REC]
1.EXT REC MODE OFF
2.SERIES REC OFF
OPERATION/EXT REC
[ OPERATION ]
1.RECOVERY REC NORMAL REC
2.REPEAT REC OFF
3.LANGUAGE SELECTION ENGLISH
4.WATER MARK OFF
5.OPERATION LOCK
ALL
[EXT REC]
1.EXT REC MODE OFF
2.SERIES REC OFF
71