Level 1 and 2 Service Manual
Removing and Replacing the Camera Assembly
6809468A80
1.
Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly, flip assembly cover, and CLI lens cover as
described in the procedures.
1.
, and flip display lens as described in the procedures.
2.
Unlock the ZIF connector and remove the camera assembly flex connector.
3.
Carefully lift the camera assembly and flex out of the flip assembly (see Figure
18).
Camera Assembly
Figure 18. Camera Assembly Removal
4.
To replace, carefully press the camera assembly into its slot in the flip
assembly.
5.
Insert the end of the camera assembly flex cable into its slot in the ZIF
connector on the flip display assembly.
6.
Replace the CLI lens cover, flip assembly cover, transceiver board, rear
housing, antenna, SIM, battery, and battery connector as described in the
procedures.
September 30, 2003
Disassembly
Display Assembly PCB
Flex ZIF Connector
39