Level 1 and 2 Service Manual
6809468A80
5.
Carefully lift the rear housing away from the front housing and flip assembly.
Housing Latch
Figure 6. Removing the rear housing
6.
To replace, carefully align the rear housing to the front housing and the flip
assembly, then press the rear chassis assembly down until the 2 housing
catches engage with the corresponding openings on the rear chassis assembly.
Press the housings together until the catches snap into place.
7.
Replace the 4 transceiver screws and tighten to a final torque setting of 1.5
inch pounds or. Do not over tighten.
8.
Replace the 2 rubber screw covers near the antenna.
9.
Replace the antenna, SIM, battery, and battery cover as described in the
procedures.
September 30, 2003
Disassembly
031832o
25