Level 1 and 2 Service Manual
Removing and Replacing the Flip CLI Lens Cover
6809468A80
1.
Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly and flip assembly cover as described in the
procedures.
2.
Use the disassembly tool to release the 2 CLI lens cover latches on each side
of the CLI Lens cover (see Figure 17).
3.
Lift the CLI lens cover away from the flip assembly.
4.
Carefully lift the CLI Lens snubber away from the flip assembly.
A
Latch
B
Snubber
Figure 17. Removing the Flip CLI Lens Cover
5.
To replace, place the CLI lens snubber into position over the connect the CLI
display Flex connector to the flip assembly.
6.
Carefully place the CLI lens snubber onto the CLI display lens assembly.
Ensure that the snubber fits snugly over the CLI display lens assembly, camera
and other flip assembly components. Be careful not to damage any of the flex
cables or flex connectors while positioning the CLI display lens snubber.
September 30, 2003
CLI Display Cover
Latch
Display Assembly
Disassembly
Disassembly T
Plastic Tweezers
37