Level 1 and 2 Service Manual
Removing and Replacing the Camera Assembly
6809488A90
1.
Remove the battery cover, battery, SIM card, stylus, rear housing, and
transceiver board assembly as described in the procedures.
2.
Use the disassembly tool to carefully pry the camera flex connector from its
mating connector on the transceiver board (see Figure 15).
Figure 15. Removing the Camera Assembly
3.
To replace, insert the camera flex connector squarely into its mating connector
on the transceiver board and press firmly until it snaps into place.
4.
Replace the transceiver board, rear housing, stylus, SIM card, battery, and
battery cover as described in the procedures.
September 20, 2004
Disassembly Tool
Camera Flex Connector
Disassembly
31