Removing And Replacing The Camera Assembly - Motorola V3 Service Manual

Disassembly

Removing and Replacing the Camera Assembly

G
32
1. Remove the battery cover, battery, SIM, antenna, rear housing, and
transceiver board assembly, flip assembly cover, and CLI lens cover as
described in the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2. Unlock the ZIF connector and remove the camera assembly flex connector.
3. Carefully lift the camera assembly and flex out of the flip assembly (see Figure
13).
Camera Assembly
Figure 13. Camera Assembly Removal
4. To replace, carefully press the camera assembly into its slot in the flip
assembly.
5. Insert the end of the camera assembly flex cable into its slot in the ZIF
connector on the flip display assembly. Avoid damage to the flex cable.
6. Replace the flip assembly cover, transceiver board, rear housing, antenna, SIM,
battery, and battery cover as described in the procedures.
July 30, 2004
Camera Flex
ZIF Connector
V3
6809485A72-O