Motorola V300 Service Manual page 28

Disassembly
28
3. Lift the transceiver board assembly out of the front housing. See Figure 9.
Figure 9. Removing the transceiver PC board assembly
4. To replace, insert the transceiver board assembly into the front housing with
the flex connector on top.
➧
Be sure the volume/smart buttons and voice button are correctly positioned in
relation to the corresponding switches on the transceiver board. Verify operation of
the buttons after replacing the transceiver board and rear chassis assembly.
5. Insert the flex connector squarely into its mating connector on the transceiver
board and press firmly until it snaps into place.
6. Replace the rear housing, antenna, SIM, battery, and battery cover as
described in the procedures.
Transceiver PCB Assembly
September 30, 2003
V300/V500
031641o
6809468A80