Removing And Replacing The Camera Assembly - Motorola V3m Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Camera Assembly

G
6809501A48-A
1. Remove the battery cover, battery, antenna, rear housing, and transceiver
board assembly, flip assembly cover, and CLI lens cover as described in the
procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2. Unlock the ZIF connector and remove the camera assembly flex connector.
3. Carefully lift the camera assembly and flex out of the flip assembly (see
Figure 20).
Figure 20. Camera Assembly Removal
4. To replace, carefully press the camera assembly into its slot in the flip
assembly.
5. Insert the end of the camera assembly flex cable into its slot in the ZIF
connector on the flip display assembly. Avoid damage to the flex cable.
6. Replace the flip assembly cover, transceiver board, rear housing, antenna,
battery, and battery cover as described in the procedures.
November 03, 2006
Camera Assembly
Disassembly Tool
ZIF Connector
Disassembly
051352a
37