Figure 8-27.Adhere Flip Flex Into Front Housing - Motorola Astro XTS 4000 Service Manual

8-20
2. While holding the Flip Assembly (A), feed the Flip Flex (2) through the top opening of the
Front Housing.
3. With the flip in the open position, assemble the Flip Assembly as follows:
a. Guide the Flip Assembly onto the left knuckle of the Front Housing. Ensure the flip flex is
fully inserted in the opening hole of the left knuckle.
b. Gently open a gap on the right knuckle of the Front Housing while simultaneously pushing
the Flip Assembly to engage the Hinge. Simultaneously press on the side of both knuckles
and rotate the flip to ensure the hinge is fully inserted into the front housing slot.
4. Peel off the liner of the Flip Flex as shown in
between the Front Housing alignment tabs. Press fit for 10 seconds to ensure the adhesive is
properly activated.
5. Insert the Microphone Boot (8*) into the Front Housing. Gently push the Microphone into the
Microphone Boot. Verify that the Microphone is fully seated.
6. Assemble the Flip Bumper Pad (11) by inserting and fully depressing the tabs into the
openings of the Front Housing located in the region between the Keypad and the Speaker
Flex compartment.
NOTE: Be careful not to stress the board when plugging the Speaker Flex Connector to the
Be careful not to pull or pinch the Flip Flex during the
assembling process.
Figure 8–27. Adhere Flip Flex into Front Housing
UCM board (10).
Disassembly/Reassembly Procedures: Radio Reassembly
Figure 8–27. Rotate the flex into position