Radio Reassembly; Figure 8-23.Removing Cid Bezel - Motorola Astro XTS 4000 Service Manual

Disassembly/Reassembly Procedures: Radio Reassembly
3. Insert the pointed tip of the Black Stick into one of the screw holes to push out the CID Bezel
Kit (1).
4. Insert the flat part of the Black Stick between the CID Bezel Kit (1) and the Flip Sub-Assembly
(3), slowly and gently sweep downwards to release the adhesive of the CID Bezel Kit (1) from
the Flip Sub-Assembly.
5. Remove the CID Bezel Kit (1) from the tongue in area of the Flip Sub-Assembly (3).
6. Use the flat end of the black stick to remove the adhesive between the Flip Flex (2) and outer
flip housing and to unplug the Flip Flex from the Display Module flex connector.
NOTE: The Flip Flex cannot be reused after removed. It must be replaced with a brand new part.
7. Gently pull out the Flip Flex (2) from the hinge compartment of the Flip Sub-Assembly (3).
8.7

Radio Reassembly

This section contains instructions for reassembling the radio.
Extreme care must be taken during removal of the CID Bezel Kit (1),
particularly near the thin ribs adjacent to the CID Display.
Gently sweep
in this direction
Figure 8–23. Removing CID Bezel
All disassembled interfaces requiring adhesive must have new
adhesive applied during reassembly. The adhesive surfaces must be
clean and free of all foreign material, including oils and/or any
remaining adhesive after disassembly. If necessary, the surfaces
may be cleaned using a 0.5% solution of a mild dishwashing
detergent in water applied sparingly to the surface, ensuring that no
water enters into adjacent openings (connectors or otherwise),
cracks, or crevices. Remove the solution and dry the surface using a
lintless cloth or tissue. All newly applied adhesive interfaces should
be press fit for 10 seconds to ensure sealing capability is retained.
CID Display
8-17