Figure 8-19.Removing Front Housing From Flip Assembly; Figure 8-20.Removing Tabs From Flip Stopper Pad - Motorola Astro XTS 4000 Service Manual

Disassembly/Reassembly Procedures: Radio Disassembly
9. With the flip in the open position, insert the flat end of the Black Stick between the flip
assembly (A) and the Front Housing. With a corner of the Black Stick positioned as shown in
Figure
twisting the Black Stick until the Flip Assembly separates.
10. Put the Flip Assembly (A) aside. Remove the Flip Bumper Pad (11) from the Front Housing.
11. Remove each tab of the Flip Stopper Pad (7) as shown in
the Black Stick, slide the tab while simultaneously pushing it through the opening in the Front
Housing. Then, pull the flip stopper from the side of the front housing to remove the flip
stopper.
8–19, gradually increase the gap between the Flip Assembly and Front Housing by
Do not twist or pull the Flip Flex as this might cause
permanent damage to the Flip Flex.
Figure 8–19. Removing Front Housing from Flip Assembly
Figure 8–20. Removing Tabs from Flip Stopper Pad
Figure 8–20. Using the flat end of
8-15