Figure 8-21.Removing Microphone Boot And Microphone From Front Housing; Figure 8-22.Separating Hinge From Flip Inner Housing - Motorola Astro XTS 4000 Service Manual

8-16
12. Remove the Microphone Boot (8*) and microphone from the Front Housing by gently lifting
the Microphone Boot from the side with the flat end of the Black Stick as shown in
Figure
Figure 8–21. Removing Microphone Boot and Microphone from Front Housing
8.6.4 Disassemble the Flip Assembly
To disassemble the flip assembly (A):
1. Slowly insert the Audio Jack Assembly Tool (refer
page 8-3
positioning the Flip Flex (2) above the tool as shown in
towards the Hinge (4) to separate the hinge from the Flip Assembly.
2. Peel off the Flip Inner Label (6) from the Flip Sub-Assembly (3) with a tweezers. With the CID
Bezel Kit (1) facing down, remove the 2 screws with a Torx T6 bit.
8–21. Separate the Microphone Boot from the microphone.
for part number) into the Flip Flex opening of the Flip Assembly (A), while
Figure 8–22. Separating Hinge from Flip Inner Housing
Disassembly/Reassembly Procedures: Radio Disassembly
"8.2 Required Tools and Supplies" on
Figure 8–22. Lightly push the tool