Disassembly Of Front Cover Assembly - Motorola FLASHpot Handie-Talkie MTX Series Service Manual

Disassembly of
Front Cover
Assembly
34
Clip 5
Clip 4
Switch Housing
Cover
Switch
Housing
Clip 3
Figure 10 Switch Housing Retaining Clips
c. The cover will pop loose from the switch housing.
3. Push the three switches and the LED out of the switch housing.
4. The remainder of the controls flex is attached to the switch
housing with adhesive. Do not remove the flex from the switch
housing unless it is absolutely necessary.
1. On top display model radios only, release the display board by
using a "press and pull" action on the top two corners of the
display board. Press down on the two top corners of the display
board and pull the top of the board away from the two corner
retaining tabs. The display board will free itself from the retaining
tabs and two retaining slots in the front cover housing.
2. Remove the wedge connector (part of the front cover flex, located
behind the universal connector), by sliding it out of the plastic
rails that hold it in place. A slight prying action, alternating back
and forth on the bottom corners of the connector, achieves the
best results. Be careful not to damage the spring contacts on the
wedge.
3. Remove the speaker retainer bracket, speaker, microphone, and
front cover flex from the front cover housing (see Figure 11).
Small Flat Blade
Screwdriver
Speaker
Retainer Bracket
Figure 11 Removing the Speaker and Flex From the Front Cover
Clip 1
Clip 2
Lift
Tab
MAEPF-22576-O
Sound
Dampening
Pad
Retaining
Tab
Front Cover
Assembly
MAEPF-22577-B