Tow/Haul Transmission Mode; Map Light Switch; Hazard Warning Flashers - Winnebago Sightseer 30A Operator's Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
TOW/HAUL TRANSMISSION
MODE
®
Ford Chassis only
This mode locks out Overdrive and helps
reduce gear "hunting" by the automatic
transmission while towing. It also improves
power delivery and uses engine braking to help
control vehicle speed when descending hills.
This mode may also be useful when the coach
is fully loaded or when driving into a strong
headwind.
• Press the button at the end of the shift
lever to engage Tow/Haul Mode
when pulling a trailer or tow vehicle
Further Information
See the chassis manual in your InfoCase for
further operating instructions and cautions.

MAP LIGHT SWITCH

Turn the driver side Map Light on using the
light dimmer wheel (located on dash). Roll it up
to maximum position until you feel it click into
the Map Light "On" position.
Further Information
Refer to the chassis manual provided in your
InfoCase for more information on the driver side
Map Light switch.
3-8
Driver Side Map Light Switch
(Located on dash)
• Roll light dimmer wheel upward fully to
turn driver side Map Light on
Passenger Side Map Light Switch
(Located on passenger side
trim panel)
• Press switch UP to turn ON
• Press switch DOWN to turn OFF

HAZARD WARNING FLASHERS

The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
Further Information
See your chassis manual for instructions on
activating, operating, and canceling hazard
warning flashers.